HIKVISION DS-K1A802AMF-B User Manual

NIC Type
Select a NIC type from the drop-down list. You can select either Self-adapve, 10M, or 100M.
DHCP
If you disable the funcon, you should manually set the device's IPv4 address, IPv4 subnet
mask, IPv4 default gateway, MTU, and port.
If you enable the
funcon, the system will automacally assign IPv4 address, IPv4 subnet mask,
IPv4 default gateway for the device.
HTTP
Set the HTTP port, DNS1 server address, and DNS2 server address.
7.2.2 Network Center Parameters
Sengs
You can set the nofy security center, center's IP address, the port No., the protocol (EHome), the
EHome account user name,etc. to transmit data via EHome protocol.
On the Device for Management page, click
→ Network → Network Center Parameters to enter
the Network Center Parameters Sengs tab.
Select a center from the drop-down list.
Aer enabling the funcon, you can set the center's address type, IP address/domain name, port
No., EHome user name, etc.
Click Save.
7.2.3
Congure Wi-Fi
Steps
1.
On the Device for Management page, click → Network → Wi-Fi to enter the Wi-Fi Sengs
tab.
2.
Check Enable to enable the Wi-Fi
funcon.
3.
Enter the SSID name and password or you can select a network from the Wi-Fi list.
4.
Set the Wi-Fi Security Mode from the drop-down list.
5.
Oponal: Click Refresh to refresh the network status.
6.
Oponal: Set WLAN parameters.
1) On the Wi-Fi Sengs page, click WLAN to enter the WLAN page.
2) Uncheck DHCP and set the IP address, the subnet mask, the default gateway, the MAC
address, the DNS1 IP Address, and the DNS2 IP address.
7.
Click Save.
DS-K1A802A Series Fingerprint Time Aendance Terminal User Manual
105

HIKVISION DS-K1A802AMF-B Specifications

General

Brand	HIKVISION
Model	DS-K1A802AMF-B
Category	Touch terminals
Language	English