HIKVISION DS-K1A802AMF-B User Manual

Note
The device's IP address and the PC's should be in the same network segment.
4.
Oponal: Enable DHCP.
The system will
automacally assign IP address for the device.
5.
Press ESC and select Yes to save the parameters and return to the previous menu.
5.4.2 Set Wi-Fi Parameters
You can enable the Wi-Fi funcon and you can transmit the data via Wi-Fi.
Steps
Note
The funcon is supported by parts of the device models.
1.
Move the cursor and select Comm. → Wi-Fi .
2.
Press OK to enter the Wi-Fi page.
Figure 5-2 Wi-Fi Page
3.
Enable the Wi-Fi funcon.
4.
Select a Wi-Fi from the list and set the Wi-Fi parameters, including the Wi-Fi password and
DHCP.
-
Enable DHCP, and the system will automacally assign IP address for the Wi-Fi.
-
Disable DHCP, and you should set the IP address, subnet mask, and gateway.
5.
Press ESC and select Yes to save the parameters.
DS-K1A802A Series Fingerprint Time Aendance Terminal User Manual
16

HIKVISION DS-K1A802AMF-B Specifications

General

Brand	HIKVISION
Model	DS-K1A802AMF-B
Category	Touch terminals
Language	English