HIKVISION DS-K1A802AMF-B User Manual

7.3 Set Access Control Parameters
Steps
1.
On the Device for Management page, click → Others → Access Control Parameters to enter
the Access Control Parameters tab.
2.
Check the checkbox to enable the
funcon.
Voice Prompt
If you enable this funcon, the voice prompt is enabled in the device. You can hear the voice
prompt when
operang in the device.
Press Key to Enter Card Number
If you enable this funcon, you can input the card No. by pressing the key.
3.
Click Save.
7.4 Change Device Password
You can change the device password.
Before You Start
Make sure the device is acvated. For details, see Acvaon.
Steps
1.
On the Device for Management page, click → System → User to enter the User tab.
2.
Select a user and click Edit to enter the Edit page.
3.
Input the old password, create a new password, and
conrm the new password.
Cauon
The password strength of the device can be automacally checked. We highly recommend you
change the password of your own choosing (using a minimum of 8 characters, including at least
three kinds of following categories: upper case leers, lower case leers, numbers, and special
characters) in order to increase the security of your product. And we recommend you reset your
password regularly, especially in the high security system, reseng the password monthly or
weekly can
beer protect your product.
Proper conguraon of all passwords and other security sengs is the responsibility of the
installer and/or end-user.
4.
Click OK.
Result
The device password is changed. You should enter the new password on the Device for
Management page to reconnect the device.
DS-K1A802A Series Fingerprint Time Aendance Terminal User Manual
106

HIKVISION DS-K1A802AMF-B Specifications

General

Brand	HIKVISION
Model	DS-K1A802AMF-B
Category	Touch terminals
Language	English