HIKVISION DS-PHA20-W2P User Manual

1) Select a device and click on the online device list.
2) Change the device IP address to the same subnet with your computer and set port number
as 80.
3) Enter the admin password of the device and click OK to complete
modicaon.
10. Oponal: Check the device on the online device list and click Add to add the device to the
device list.
3.3 Acvate via SADP
SADP is a tool to detect, acvate and modify the IP address of the device over the LAN.
Before You Start
• Get the SADP
soware from the supplied disk or the ocial website hp://
www.hikvision.com/en/ , and install the SADP according to the prompts.
• The device and the PC that runs the SADP tool should be within the same subnet.
The following steps show how to
acvate a device and modify its IP address. For batch acvaon
and IP addresses modicaon, refer to User Manual of SADP for details.
Steps
1. Run the SADP
soware and search the online devices.
2. Find and select your device in online device list.
3. Input new password (admin password) and
conrm the password.
Cauon
STRONG PASSWORD RECOMMENDED-We highly recommend you create a strong password of
your own choosing (using a minimum of 8 characters, including upper case leers, lower case
leers, numbers, and special characters) in order to increase the security of your product. And
we recommend you reset your password regularly, especially in the high security system,
reseng the password monthly or weekly can beer protect your product.
4. Click Acvate to start acvaon.
Hybrid Security Control Panel User Manual
7

HIKVISION DS-PHA20-W2P Specifications

General

Brand	HIKVISION
Model	DS-PHA20-W2P
Category	Control Panel
Language	English