HIKVISION DS-PHA20-W2P User Manual

Figure 4-12 Channel 3
Nocaon
Push
When an alarm is triggered, if you want to send the alarm nocaon to the client, alarm center,
cloud or mobile phone, you can set the nocaon push parameters.
Steps
1. In the client soware, select the device on the Device Management page and click , or enter
the device IP address in the address bar of the web browser and log in.
2. Click
Conguraon → Communicaon Parameters → Event Communicaon .
3. Enable the target
nocaon.
Zone Alarm & Tampering Alarm Nocaon
The device will push nocaons when the zone alarm (on web client, soware client or
mobile client) is triggered or the zone tampering alarm is triggered or restored.
Device Tampering Alarm
Nocaon
The device will push nocaons when tampering alarm of any device is triggered or
restored.
Control Panel Tampering Alarm Nocaon
Hybrid Security Control Panel User Manual
22

HIKVISION DS-PHA20-W2P Specifications

General

Brand	HIKVISION
Model	DS-PHA20-W2P
Category	Control Panel
Language	English