HIKVISION DS-PHA64-M User Manual

Result
Note
You can arm/disarm/clear alarm via sending SMS. The number of the SIM card installed in the
control panel is the receiver number.
You can send help to the control panel to get the SMS command list.
The control message is Command +
Operaon Type + Target , and the details are show below.
For examples, command 00+1+1 indicates area 1 disarming, and command 01+1+1 indicates area 1
away arming.
Command Operaon Type Target
2 Digits
00: Disarming
01: Away Arming
02: Stay Arming
03: Alarm Clearing
1 Digit
1: Area Operaon
No more than 3 Digits
0: All area arming/disarming/
clearing Alarm
1: Area 1 arming/disarming/
clearing Alarm
...
4: Area 4 arming/disarming/
clearing Alarm
...
Mobile Client Registraon
If you want to register the device to the mobile client for remote conguraon, you should set the
mobile client registraon parameters.
Before You Start
• Connect the device to the network via wired
connecon, dial-up connecon, or Wi-Fi
connecon.
• Set the device IP address, subnet mask, gateway and DNS server in the LAN.
Steps
1. In the client
soware, select the device on the Device Management page and click , or enter
the device IP address in the address bar of the web browser and log in.
2. Click Conguraon → Communicaon Parameters → Hik-Connect Registraon to enter the
Hik-Connect
Registraon Sengs page.
Hybrid Security Control Panel User Manual
25

HIKVISION DS-PHA64-M Specifications

General

Brand	HIKVISION
Model	DS-PHA64-M
Category	Control Panel
Language	English