HIKVISION DS-PHA64-M User Manual

Key Zone
• By Zone Status → Trigger Arming: The linked area will away arm
aer detectors being
triggered, and disarm aer being restored. Reports will be upload.
• By Zone Status → Trigger Disarming: The linked area will disarm
aer detectors being
triggered, and away arm
aer being restored. Reports will be upload.
• By Trigger Time: When the key zone is triggered, if the device has been armed, the linked
area will be disarmed; if the device has been disarmed, the linked area will be armed.
Reports will be upload.
• In the case of the tampering alarm, the arming and disarming
operaon will not be
triggered.
4. Set the zone sensivity and zone resistor.
Note
The resistor wired on the on-board zone should be the same as the resistor congured on this
page.
5. Select a detector type.
6. Enable Stay Arming Bypass, Silent Alarm, Dual-Zone Sengs, Forbid Bypass on Arming and
Double knockaccording to your actual needs.
Note
Some zones do not support the funcon. Refer to the actual zone to set the funcon.
Dual-Zone
Aer enable the Dual-Zone Sengs, one zone can be expanded to two zones.
Forbid Bypass on Arming
Aer enabled, you can not bypass zones when arming.
Double knock
Aer enabled, the me interval can be set. If the same detector is triggered twice or
connuously in a period of me, the alarm will be triggered.
7. Select the panel video channel No. and zone tampering wiring mode.
8. Click OK.
Note
Aer seng the zone, you can enter Device Status → Zone to view the zone status.
Wireless Zone Sengs
Steps
1. Select a wireless zone and click to enter the Zone Sengs page.
Hybrid Security Control Panel User Manual
33

HIKVISION DS-PHA64-M Specifications

General

Brand	HIKVISION
Model	DS-PHA64-M
Category	Control Panel
Language	English