HIKVISION DS-PHA64-M User Manual

Enable the area to automacally arm itself in a specic me point.
Auto Arm Time
Set the schedule for the area to automacally arm itself.
Late to Disarm
Enable the device to push a nocaon to the phone or tablet to remind the user to disarm the
area when the area is sll armed aer a specic me point.
Note
You should enable the Panel Management Nocaon funcon on the Web Client of
Communicaon Parameters → Event Communicaon before enabling the Late to Disarm
funcon.
Late to Disarm Time
Set the me point menoned in Late to Disarm.
Weekend Excepon
If enabled, Auto Arm, Auto Disarm, and Late to Disarm are disabled on the weekend.
Excepted Holiday
Enable the funcon and the zone will not be armed/disarmed in the holiday. You should set the
holiday schedule aer enabling.
Note
Up to 6 holiday groups can be set.
4.3.13 Check System Status (Zone Status/Communicaon Status)
You can view the zone status and the communicaon status via the mobile client.
View Zone Status
In the Area page, tap Zone to enter the Zone tab. You can view the each zone's status in the list.
Communicaon Mode
In the Area page, tap → Device Informaon to enter the page. You can view the device
communicaon status, including the baery, Ethernet network, Wi-Fi, mobile network, data usage
and so on.
Enable Arming Process
In the Area page, tap to enter the page. Slide to enable Enable Arming Process. Aer enabled,
the device will auto detect its faults during the arming process. You can determine whether to
connue arming or not if faults are detected.
Hybrid Security Control Panel User Manual
78

HIKVISION DS-PHA64-M Specifications

General

Brand	HIKVISION
Model	DS-PHA64-M
Category	Control Panel
Language	English