HIKVISION iDS-TCV500-BI User Manual

Network Traffic Camera • User Manual
21
Device Information
Set Serial Ports
Purpose:
Set the RS-485 parameters and RS-232 parameters in this page.
 The RS-485 ports are used to input signals related to traffic control, such as RS-485 radar and
vehicle detector. The number of available RS-485 ports can be different according to different
device models.
 The RS-232 port can be used in two ways:
− Parameters Configuration: Connect a computer to the device through the serial port.
Device parameters can be set by using software such as HyperTerminal. The
serial port parameters must be the same as the serial port parameters of
the device.
− Transparent Channel: Connect a serial device directly to the device. The serial device

HIKVISION iDS-TCV500-BI Specifications

General

Card reader integrated	Yes
Maximum memory card size	128 GB
Maximum resolution	2464 x 2056 pixels
Image quality adjustment	Saturation, Brightness, Contrast, Sharpness, DNR
Video compression formats	H.264, H.265
Placement supported	Outdoor
Signal-to-Noise Ratio (SNR)	60 dB
Number of users	32 user(s)
Supported network protocols	TCP/IP, HTTP, HTTPS, FTP, DNS, DDNS, RTP, RTSP, RTCP, NTP, UPnP, IPv6, UDP
Focus	Motorized/Manual
Minimum illumination	0.001 lx
Housing material	Aluminum
International Protection (IP) code	IP66