HIKVISION iDS-TCV500-BI User Manual

Network Traffic Camera • User Manual
28
(Optional) you can also check Synchronize with PC. The device time is synchronized with
the time of your computer.
Click Save to save the settings.
 NTP Synchronization
Select Synchronization Mode as NTP Synchronization.
NTP Synchronization
Set the following settings:
 Server Address: IP address of NTP server.
 NTP Port: Port of NTP server.
 Interval: The time interval between the two synchronizing actions with NTP server.
If the device is connected to a public network, you should use a NTP server that has a time
synchronization function, such as the server at the National Time Center (IP Address:
210.72.145.44). If the device is set in a customized network, NTP software can be used to establish
a NTP server for time synchronization.
Click Save to save the settings.
Configuring DST (Daylight Saving Time)
Go to Configuration > Device Configuration > System Configuration > DST.
Check Enable DST.
Set Start Time, End Time, and DST Bias.
Click Save to save the settings.

HIKVISION iDS-TCV500-BI Specifications

General

Card reader integrated	Yes
Maximum memory card size	128 GB
Maximum resolution	2464 x 2056 pixels
Image quality adjustment	Saturation, Brightness, Contrast, Sharpness, DNR
Video compression formats	H.264, H.265
Placement supported	Outdoor
Signal-to-Noise Ratio (SNR)	60 dB
Number of users	32 user(s)
Supported network protocols	TCP/IP, HTTP, HTTPS, FTP, DNS, DDNS, RTP, RTSP, RTCP, NTP, UPnP, IPv6, UDP
Focus	Motorized/Manual
Minimum illumination	0.001 lx
Housing material	Aluminum
International Protection (IP) code	IP66