HIKVISION iDS-TCV500-BI User Manual

Network Traffic Camera • User Manual
25
When setting the Server Address, you need to cooperate with IPServer software and IVMS client
software. For how to use it, refer to relevant IPServer and IVMS client software documentation.
Click Save.
Set EHome
Purpose:
The device can remotely access the platform through the EHome protocol, and control the device
through the platform to realize operations such as picture uploading.
Before you start:
The device is properly connected to the platform.
Go to Configuration > Device Configuration > System Configuration > EHome.
EHome Settings
Check Enable.
Enter corresponding parameters.
 Encryption Key: The encryption key need to be entered when you access to platform
according to the encryption key set here.
 Registration Status: You can check if you have accessed to EHome platform.
Click Save.

HIKVISION iDS-TCV500-BI Specifications

General

Card reader integrated	Yes
Maximum memory card size	128 GB
Maximum resolution	2464 x 2056 pixels
Image quality adjustment	Saturation, Brightness, Contrast, Sharpness, DNR
Video compression formats	H.264, H.265
Placement supported	Outdoor
Signal-to-Noise Ratio (SNR)	60 dB
Number of users	32 user(s)
Supported network protocols	TCP/IP, HTTP, HTTPS, FTP, DNS, DDNS, RTP, RTSP, RTCP, NTP, UPnP, IPv6, UDP
Focus	Motorized/Manual
Minimum illumination	0.001 lx
Housing material	Aluminum
International Protection (IP) code	IP66