HIKVISION iDS-TCV500-BI User Manual

Network Traffic Camera • User Manual
61
 Motor vehicle, Non-motor vehicle, and Pedestrian: It captures motor vehicle, and non-motor
vehicle, and pedestrian.
 Motor Vehicle: Only motor vehicle will be captured.
5) Select Capture Mode. The capture mode is associated with the connected type of
flash light. Strobe and Burst are selectable.
 Strobe: It adopts the frame extracting, and the captured pictures share the same exposure
parameters with the video image.
 Burst: It adopts the separate exposure.

A reboot is required when two modes switch.

If you set the capture mode as Burst, the capture image shares the same parameters with
the video image.

The Section 12.5 Configuring Picture is not supported when you select Strobe as the
capture mode.
6) Select Speed Detect Mode. N/A, Radar, and Video are selectable. N/A refers to
disable the speed detection.
Set corresponding mixed-traffic lane parameters.
Mixed-Traffic Lane Configuration
1) Select Total Lanes from the drop-down list. Up to 2 lanes can be selected.
2) Click the lane tab to select the lane to set.
3) Select Lane Direction.
4) Set the linkage lane by entering Linked Lane No., e.g.: if you select lane 1, the system
will give the speed of lane 1 detected by radar.

HIKVISION iDS-TCV500-BI Specifications

General

Card reader integrated	Yes
Maximum memory card size	128 GB
Maximum resolution	2464 x 2056 pixels
Image quality adjustment	Saturation, Brightness, Contrast, Sharpness, DNR
Video compression formats	H.264, H.265
Placement supported	Outdoor
Signal-to-Noise Ratio (SNR)	60 dB
Number of users	32 user(s)
Supported network protocols	TCP/IP, HTTP, HTTPS, FTP, DNS, DDNS, RTP, RTSP, RTCP, NTP, UPnP, IPv6, UDP
Focus	Motorized/Manual
Minimum illumination	0.001 lx
Housing material	Aluminum
International Protection (IP) code	IP66