HIKVISION Pyronix EURO 46 V10 User Manual

20
EURO 46 V10 Programming Manual
10. ‘Set Point Sets’ will be displayed. Select the area(s).
Press .
11. ‘Set Point Unsets’ will be displayed. Select the area(s).
Press .
12. ‘Set Point In’ will be displayed. Enter the Area in which
the Arming Station is situated and press .
13. ‘Set Point Description’ will be displayed. Press  to
enter the name and location if required.
14. ‘Enter Name’ will be displayed. Enter the name of the
wireless Arming Station and press .
15. ‘Enter Location’ will be displayed. Enter the location of
the wireless Arming Station and press .
16. Press b or d to select another device address
to program 7 - 9 or press the  key to return to the
Engineer menu.
Change Timers?
Timers Description Options
Entry Time
(01ABCD)
Programs the entry time for each area.
PLEASE NOTE: Ensure that the timer is no longer than 45 seconds in order to comply with
EN50131-1.
0-255 seconds
Entry Time 2 Same as above therefore allowing for different timers on 2 entry routes. 0-255 seconds
Exit Time
(01ABCD)
Programs the exit time for each area. 0-255 seconds
APP Exit
Time
Programs the exit time for each area that is applied when the area is set using the
HomeControl+ Android or iOS App.
PLEASE NOTE: This time must be set at 30 seconds or more to comply with
PD6662:2010+IA:2015.
0-199 seconds
Siren Time
(01ABCD)
Program the length of time an external sounder will be audible for. 2-15 minutes
Siren Delay
The delay after the intruder alarm before bell activates.
PLEASE NOTE: Not valid within three minutes of final set, or after entry time started. If ‘Silent
1st Alarm’ is selected in alarm responses the delay commences at confirmed alarm.
0-20 minutes
Confirm
Time
Time period during which a second activation must occur to qualify as a ‘sequentially
confirmed’ alarm.
PLEASE NOTE: BS8243 specifies a confirm time between 30 and 60 minutes. This can also
be used in conjunction with testing an omit signal.
1–99 minutes
HU Confirm
Time
Time period during which a second activation on a hold alarm must occur to qualify as a
‘sequentially confirmed’ alarm.
PLEASE NOTE: BS8243 specifies a confirm time between eight and 20 hours. This can also
be used in conjunction with testing an omit signal.
8 – 20 hours
Set Points Sets
[01ABCD]
Set Point Unsets
[01ABCD]
Set Point In
[01ABCD]
Set Point
Description?
Enter Name
Station 01
Enter Location
_

HIKVISION Pyronix EURO 46 V10 Specifications

General

Brand	HIKVISION
Model	Pyronix EURO 46 V10
Category	Security System
Language	English