28
EURO 46 V10 Programming Manual
Diagnostics?
This option enables the engineer to perform full diagnostics on all key wired and wireless
components of the system.
Wireless Devices
View Inputs:
This option views the status of all wireless inputs: O=Open, C=Closed, T=Tamper, B=Battery and
S=Supervision.
View Inputs / Bells Signal Strength:
This option is used to view the signal strength for any wireless input, bell or arming station that is
learnt to the system. The signal strength is shown on both the individual wireless device and on the
panel in the following ways:
PLEASE NOTE: When doing any wireless signal strength or battery tests, it is recommended to wait a
full 5 minutes to analyse the devices fully.
Wireless Device:
• If a green LED is shown the signal strength is High.
• If a red LED is shown the signal strength is Low.
Control Panel Display:
Once one of the signal strength menus has been entered, ‘Please Wait’ will be displayed and a
countdown from 300 seconds will begin. This may last up to five minutes before all of the wireless
devices have been analysed. From this point each device is tested every 15 seconds. On the LCD
display it is also possible to view each individual device’s signal strength as a percentage.
3 = Excellent signal – Shows green on the wireless Device / 80 to 100%
2 = Good signal – Shows green on the wireless Device / between 30 to 80%
1 = Weak signal – Shows red on the wireless Device / between 1 to 30%
0 = Missing – Has no signal
‘?’ = Waiting for device signal strength information
PLEASE NOTE: All wireless inputs are subject to signal strength fluctuation, based on this it is
recommended that all wireless devices be installed at a minimum of ‘2’ signal strength.
View Inputs / Bells/ Arming Stations - Battery Status?
This option is used to measure the battery levels for wireless inputs and bells. The battery level is
shown on the control panel.
Once the battery status menu has been entered, ‘Please Wait’ will be displayed and a countdown
from 300 seconds will begin. This may last up to five minutes before all of the wireless devices have
been analysed. From this point each device is tested every 15 seconds.
Testing = Waiting for a Battery result.
Good = At least one month of battery life remaining.
Replace = Battery needs to be replaced immediately.
To Next Page
Loading...
Need help?
General
