33
EURO 46 V10 Programming Manual
Day Alarm Starts at:
This feature programs the starting point of the alarm responses for a 24 hour alarm. The levels are:
‘Keypads’, ‘Internal Sounders’, ‘Sirens Only’ and ‘Digi’.
Day Alarm Stops at:
This feature programs the ending point of alarm responses for a 24 hour alarm. Chose from:
‘Keypads’, ‘Internal’ ‘Sounders’, ‘Sirens Only’ and ‘Digi’.
Start at:
This feature overrides the settings above. It can be used to create greater flexibility in the use of the
alarm responses feature and, in this case, it is set up for each area if they are in set status only.
If Areas Set
Select the areas that the following settings will be applicable to.
Stop at:
For example: if Day Alarm is set to Start at Keypad and stop at Keypad, this feature allows set up for
all Areas (if they are set) to make any alarm stop at Digi or Confirm.
If Areas Set
Select the areas that the above setting will be applicable to.
Set Up Downloading?
The control panel has uploading and downloading capabilities. The ‘InSite’ upload/download
software allows you to monitor the status of each input, alter programming and review the logs. This
software is available to download from www.pyronix.com. See the “Connecting to InSite Software”
section for further instruction on different connection methods.
Dial Out Menu?
Select PC to Dial
This menu is used to select which PC programmed in to the system you would like to dial and
connect to.
Operations
Connect to PC - Forces the panel to connect to the InSite software
Test Dial - Dials the InSite, connects and then hangs up.
ARM Service - Send an ARM service report to the InSite software.
Data from PC - Dials the InSite and downloads programming information for that panel.
Data to PC - Dials the InSite and uploads its latest configuration to the customer already created.
Diagnostics -
Commissioning - Dials the InSite, creates a new customer and uploads it’s configuration.
To Next Page
Loading...
Need help?
General
