HIKVISION Ultra Series User Manual

Parameter Descripon
Note
●
Only the device with the ngerprint module supports the
ngerprint related funcon.
●
Biometric recognion products are not completely applicable
to
an-spoong environments. If you require a higher
security level, use
mulple authencaon modes.
●
If you adopt mulple authencaon modes, you should
authencate other methods before authencang face.
Reader Auth. Mode (Card
Reader
Authencaon Mode)
Select the card reader's authencaon mode.
Enable NFC Card Enable the funcon and you can present the NFC card to
authencate. In order to prevent the mobile phone from geng
the data of the access control, you can disable NFC card to
increase the security level of the data.
Note
Disable NFC card cannot completely avoid presenng NFC card.
Enable M1 Card Enable the funcon and you can present the M1 card to
authencate.
Door Contact You can select "Remain Open" or "Remian Closed" according to
your actual needs. By default, it is Remian Closed.
Open Duraon Set the door unlocking duraon. If the door is not opened for
the set me, the door will be locked. Available door locked me
range: 1 to 255s.
Authencaon Interval Set the device authencang interval. Available authencaon
interval range: 0 to 65535.
7.9 Time and Aendance Status Sengs
You can set the aendance mode as check in, check out, break out, break in, overme in, and
overme out according to your actual situaon.
Note
The funcon should be used cooperavely with me and aendance funcon on the client
soware.
Face Recognion Terminal User Manual
63

HIKVISION Ultra Series Specifications

General

Brand	HIKVISION
Model	Ultra Series
Category	Touch terminals
Language	English