Honda CRF450R 2012 Service Manual

FRONT WHEEL/SUSPENSION/STEERING
Using quick successive motions, pull the slider out
of the outer tube.
Do nor damage the Carefully remove the slider bushing by prying the
slider bushing, slot with a screwdriver until the bushing can be
especially the pulled off by hand.
sliding surf ace. To
Remove the follow ing:
prevent loss of
tenSIOn, do not - Guide bushing
open the bushing - Back-up ring
more than - Oil seal
nec e ssary . - Stopper ring
14-18
- Dust seal
FORK DAMPER DISASSEMBLY
Set the fork damper in a vise with a piece of wood
or soft jaws to avoid damage.
Hold the fork damper assembly using the special
tool.
TOOL :
l ock nut wrench, 50 mm 07WMA·KZ30100
Remove the fork cap assembly from the fork
damper .
NOTE :
• Be careful not to damage the fork cap bushing.
• Do not disassemble the fork cap assembly.
• Rep lace the fork cap as an assembly if it is dam-
aged.
DUST SEAL
FORK CAP ASSEMBLY
FORK DAI~P"R
SLIDER
BUSHING

Honda CRF450R 2012 Specifications

General

Brand	Honda
Model	CRF450R 2012
Category	Motorcycle
Language	English