Remove the electrical connector
from the bulb by pushing on the
tab and pulling the connector
down.
Remove the bulb by turning it one-
quarter turn counterclockwise.
Open the hood. Remove the
socket from the headlight
assembly by turning it one-quarter
turn counterclockwise.
Pull the burned out bulb straight
out of its socket.
Push the new bulb straight into
the socket until it bottoms.
Push the electrical connector back
onto the bulb. Make sure it is on
all the way.
Turn on the headlights to test the
new bulb.
If you replaced the high beam
headlight bulb on the passenger’s
side, reinstall the power steering
fluid reservoir.
Insert the new bulb into the hole,
and turn it one-quarter turn clock-
wise to lock it in place.
5.
6.
7.
2.
3.
4.
2.
1.
Lights
Replacing a Front Turn Signal
Bulb
438
TAB
BULB
CONNECTOR
BULB SOCKET
Driver’s side
０９／０４／１０ １６：５８：１７ ３１ＳＨＪ６５０ ０４４３
To Next Page
Loading...
Need help?
General
