TUXEDOW INSTALLATION AND SETUP GUIDE
22
Clean Screen
With the exception of normal cleaning, the keypad is maintenance free. Clean the touch-screen as follows:
2. Touch the Disp & Audio Setup icon.
3. Enter your “Authorized Code", if required.
4. Touch the CLEAN SCREEN button to
disable the keypad for 26 seconds.
5. Touch Continue to disable the touchscreen.
6. Touch Cancel to exit.
At the "Touch Screen Disabled for =30 Seconds"
screen, the touchscreen should be wiped clean of
fingerprints using a mild soap solution and a soft cloth.
When the counter reaches zero, the window automatically
closes, and the touch-screen is active.
A pop-up window displays "Touch Screen will be
disabled so that you may wipe the screen clean. Please
use a damp, soft cloth. DO NOT use any liquids,
sprays, or ammonia-based cleansers. Touch
CONTINUE to disable touchscreen." **Panics cannot
be initiated during this process**
NOTE: The Emergency screen cannot be accessed while running in the clean screen mode.
IMPORTANT: Do not use an abrasive cleaning agent or abrasive cloth when cleaning the touch-screen or damage may
occur.
Routine Care
• Treat the components of your security system as you would any other electrical equipment. Do not slam sensor-protected
doors or windows.
• Keep dust from accumulating on the keypad and all protective sensors, particularly on motion sensors and smoke detectors.
• Keypad case and sensors should be carefully dusted with a dry soft cloth. Do not spray water or any other fluid on the
units.
Brightness and Volume Control
From the Home screen, access the Setup screen as follows:
1. From the Setup screen, touch the Disp &
Audio Setup icon.
2. Enter your “Authorized Code", if required.
3. Move the bar left or right to increase or
decrease level of brightness or volume.
Changes are saved when you exit
To Next Page
Loading...
Need help?
General
