Ultra HD IP Camera User Guide
30
4. Open the Command Prompt window on your PC (in Windows 7, click Start > All
Programs > Accessories > Command Prompt) and type the appropriate commands for
your operating system:
5. Reboot the camera. If the setup was successful, the Command Prompt window will
display “Reply from" and the IP address (for example, "Reply from 192.168.0.125 …”).
To verify that the IP address works, open your browser and type in the address bar
http:// followed by the IP address (for example, http://192.168.0.125), then press
Enter.
Configuring Network Connections
You can configure network connections and port settings on the Setup > Network Setup >
Connection > Connection page.
By default, the maximum number of simultaneous connections the camera will support is set
to 10. To change this setting, in the Max Connections field, enter a value between 1 and 20.
If you want, you can change the TCP, UDP, HTTP, RTSP, and HTTPS port numbers from their
defaults.
Click Save to apply the settings.
To Next Page
Loading...
Need help?
General
