Configuring Video and Audio Settings
19
Defog
To enable the defog function, set Mode to OFF, Manual, or Auto.
Auto The defog function is enabled automatically when the scene is obscured by fog or
haze.
Manual The defog function is always enabled.
If Mode is set to Manual, do the following:
1. Set Intensity to Low, Medium, or High.
2. Set Airlight Mode to Auto or Manual.
Auto The defog function is fine-tuned automatically (recommended).
Manual The defog function is fine-tuned by the user using the Grade slider.
Click Save to apply the settings. Note: only for H4L6GR2 and HBL6GR2.
Managing Profiles
After you have configured the camera properties for each profile (Normal, Day, Night), you
can set the profile(s) that you want the system to use on the Setup > Camera Setup > Profile
Management page.
Next to Profile Management, select Normal, Full Time, or Schedule. By default, the system
has the Day profile always enabled.
Normal The Normal profile is always enabled.
Full Time The Day profile or Night profile is always enabled, depending on your selection.
Schedule The system switches between the Day profile and Night profile. Drag the sliders on
the left and right sides of the timeline to set the Night-to-Day and Day-to-Night
switching times.
Click Save to apply the settings.
Configuring Streaming Settings
You can configure video streaming properties on the Setup > Compression Setup > Video
page.
The page is divided into two sections: Main Stream and Sub Stream. In the Sub Stream
section, two sub streams are configurable: Sub Stream 1 and Sub Stream 2. To enable a sub
stream, select one of the sub streams, and then select the Enable check box.
To Next Page
Loading...
Need help?
General
