Ultra HD IP Camera User Guide
52
Configuring Face Detection Events
You can configure face detection event settings on the Setup > Video Analytics > Face
Detection page.
To enable face detection:
1.
Select the Enable check box.
2.
Click Draw Target to set up the face detection area. You can move or resize the area using
your mouse. To move the area, drag one of the sides. To resize the area, drag one of the
corner handles.
3.
Next to Alarm Period, click Setup. The Alarm Period window opens.
4.
Set the days and times when you want the alarm function to be active, and then click
Save.
5.
To enable face enhancement, select the Enable Face Enhancement check box.
6.
To start recording video when an event is detected, select the Record check box.
7.
In the Record Delay field, enter the number of seconds that the system will continue to
record video after the event has ended. Enter a value between 10 and 300.
8.
To generate an alarm output when an event is detected, select the Alarm Output check
box and select the alarm output(s) to be activated.
9.
In the Alarm Delay field, enter the number of seconds that the system will continue to
generate an alarm output after the event has ended. Enter a value between 10 and 300.
10.
To send an email notification when an event is detected, select the Send Email check
box. Email settings must be configured in Setup > Network Setup > SMTP (Email). See
Configuring Email Settings on page 35.
11.
To take a snapshot when an event is detected, select the Snapshot check box.
Note For the snapshot to be attached to the email notification, the Attachment check box
must be selected in Setup > Network Setup > SMTP (Email).
See Configuring Email Settings on page 35.
To Next Page
Loading...
Need help?
General
