2-11
Installing the Switch
Installation Procedures
Installing the Switch
4. Mount the Switch
After the switch passes self test, you are ready to mount the switch in a stable
location. The Series 2510 Switch can be mounted in these ways:
■ in a rack or cabinet
■ on the wall
■ on a horizontal surface
Rack or Cabinet Mounting
The Series 2510 Switch is designed to be mounted in any EIA-standard 19-inch
telco rack or communication equipment cabinet.
WARNING For safe operation, please read the mounting precautions on
page 2-4, before mounting a switch.
Equipment
Cabinet
Note
The 12-24 screws supplied with the switch are the correct threading for
standard EIA/TIA open 19-inch racks. If you are installing the switch in an
equipment cabinet such as a server cabinet, use the clips and screws that came
with the cabinet in place of the 12-24 screws that are supplied with the switch.
Complete step 1, and plan which four holes you will be using in the cabinet
and install all four clips. Then proceed to step 2.
To Next Page
Loading...
Need help?
General
