IP address IP address of the RIP neighbor.
Bad routes Number of route entries which were not
processed for any reason.
Last update timeticks Number of seconds that have passed since
we received an update from this neighbor.
Viewing RIP interface information
To display RIP interface information, enter the show ip rip interface command at any
context level.
Syntax:
show ip rip interface [ ip-addr | vlan <vlan-id> ]
The resulting display will appear similar to the following:
Example 30 Output for the show IP RIP interface command
HP Switch(config)# show ip rip interface
RIP interface information
IP Address Status Send mode Recv mode Metric Auth
----------- -------- ---------- ---------- ------- ----
100.1.0.1 enabled V2-only V2-only 1 none
100.2.0.1 enabled V2-only V2-only 1 none
100.3.0.1 enabled V2-only V2-only 1 none
100.4.0.1 enabled V2-only V2-only 1 none
You can also display the information for a single RIP VLAN interface, by specifying the VLAN ID
for the interface, or by specifying the IP address for the interface.
To show the RIP interface information for VLAN 1000, use the show ip rip interface vlan
<vid> command.
Example 31 RIP interface output by VLAN
HP Switch# show ip rip interface vlan 4
RIP configuration and statistics for VLAN 4
RIP interface information for 100.4.0.1
IP Address : 100.4.0.1
Status : enabled
Send Mode : V2-only
Recv mode : V2-only
Metric : 1
Auth : none
Bad packets received : 0
Bad routes received : 0
Sent updates : 0
For definitions of the fields in Example 31, see “Viewing general RIP information” (page 56).
58 IP Routing Features
To Next Page
Loading...
Need help?
General