Configuring the console switch 37
Network settings
Only Administrators can make changes to the network settings. All other users can view network settings,
but cannot make changes.
General network settings
To configure General network settings:
1. Select Unit View>Appliance>Appliance Settings>Network>General. The Appliance General Network
Settings page appears.
NOTE: If you change the LAN speed, you must reboot the console switch.
2. Configure the following parameters:
o LAN Speed
o ICMP Ping Reply
o HTTP Port
o HTTPS Port
3. Configure the network settings for either IPv4 or IPv6 mode. The default setting is IPv4 with BOOTP
enabled. The console switch is dual-stack capable, so both can be configured simultaneously.
DNS settings
To configure DNS settings:
1. Select Unit View>Appliance>Appliance Settings>DNS. The Appliance DNS Settings page appears.
To Next Page
Loading...
Need help?
General
