Configuring the console switch 52
1.
Select Unit View>Appliance>Appliance Settings>User Accounts>LDAP>Search. The Appliance LDAP
Search page appears.
NOTE: The LDAP Search and Query parameters can only be configured if LDAP
Authentication is enabled on the LDAP Overview ("Configuring LDAP" on page 50) page.
2. Configure the Search parameters:
o Search DN—Defines the administrator-level user that the target device uses to log into the
directory service. Once the target device is authenticated, the directory service grants it access to
the directory to perform the user authentication queries specified on the LDAP query page. The
default values are cn=Administrator, cn=Users, dc=DomainName, and dc=com. Each search
value must be separated by a comma.
o Search Password—Used to authenticate the administrator or user specified in the Search DN
field.
o Search Base—Defines a starting point from which all LDAP searches begin. The default values
are dc=yourDomainName and dc=com. Each search value must be separated by a comma. For
example, to define a search base for test.com, your values are dc=test, dc=com.
o UID Mask—Specifies the search criteria for user ID searches of LDAP target devices. The format is
<name>=<%1>. The default value is sAMAccountName=%1, which corresponds to Active
Directory.
LDAP query
To configure LDAP query parameters:
To Next Page
Loading...
Need help?
General
