HP EliteOne 705 G2 User Manual

Adjustable-height stand
Attaching an adjustable-height stand
To install the stand:
1. Place the computer face down on a soft at surface. HP recommends that you set down a blanket, towel,
or other soft cloth to protect the bezel and screen surface from scratches or other damage.
2. Engage the hooks in the top of the stand in the two large holes in the upper part of the back of the
computer (1).
3. Lower the stand onto the computer (2) and press down until it clicks into place (3).
Removing an adjustable-height stand
To remove the stand:
1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 31).
2. Remove the rear port cover (see Rear port cover on page 31).
3. Press the release latch under the stand (1).
4. Lift the stand up (2), and then pull the stand hooks out of the computer (3).
34 Chapter 4 Removal and Replacement Procedures

HP EliteOne 705 G2 Specifications

General

Brand	HP
Model	EliteOne 705 G2
Category	Desktop
Language	English