Memory
Description
8-GB
4-GB
2-GB
The computer comes with small outline dual inline memory modules (SODIMMs).
The memory sockets on the system board can be populated with up to two industry-standard SODIMMs.
These memory sockets are populated with at least one preinstalled SODIMM.
For proper system operation, the SODIMMs must meet the following qualications:
EliteOne 800 and ProOne 600 EliteOne 705
SODIMM 1.2 volt DDR4-SDRAM SODIs 1.5 volt DDR3-SDRAM SODIs
Compliance unbuered non-ECC PC4-10600 DDR4-2133 MHz-
compliant
unbuered non-ECC PC3-10600 DDR3-1600 MHz-
compliant
Pins industry-standard 260 pin containing the
mandatory Joint Electronic Device Engineering
Council (JEDEC) specication
industry-standard 204 pin containing the
mandatory Joint Electronic Device Engineering
Council (JEDEC) specication
Support support CAS latency 11 DDR4 2133 MHz (11-11-11
timing)
support CAS latency 11 DDR3 1600 MHz (11-11-11
timing)
Slots 2 2
Maximum Memory 32 GB 16 GB
Supported 1 Gbit, 2 Gbit, and 4 Gbit non-ECC memory technologies single-sided and double-sided SODIMMs
Note The system will not operate properly if you install unsupported SODIMM memory. SODIMMs constructed
with x8 and x16 SDRAMs are supported; SODIMMs constructed with x4 SDRAMS are not supported.
HP oers upgrade memory for this computer and advises that the consumer purchase it to avoid
compatibility issues with unsupported third-party memory.
The system will automatically operate in single channel mode, dual channel mode, or ex mode, depending
on how the SODIMMs are installed. Refer to the following table to identify the SODIMM channel locations.
Location System board label Channel
Lower Socket SODIMM1 Channel B
Upper Socket SODIMM3 Channel A
Memory 49
To Next Page
Loading...
Need help?
General