To Next Page

To Previous Page

Rear bottom cover

The bottom rear cover hides rear ports and the RTC battery. To remove the cover, remove the caps from atop

both screws at the bottom of the computer under the feet, and then turn the screws to loosen the cover. Then

pry the cover o the computer. The following image shows screw cover locations.

To remove the rear bottom cover:

1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 17).

2. Use a tool to pry the screw covers from atop the screws.

NOTE: Only the right screw cover is shown in the following image.

18 Chapter 4 Removal and Replacement Procedures

Questions and Answers:

Need help?

Do you have a question about the HP ENVY PRO and is the answer not in the manual?

HP ENVY PRO Specifications

General