2. Select the management processors to upgrade.
3. For each selected management processor, click Browse, and then select a firmware image file. You
can also manually enter the path to the firmware image.
4. Click Upgrade Firmware.
During the firmware upgrade process, all buttons are deactivated to prevent navigation.
The selected management processors are upgraded. Although HPLOMIG enables you to upgrade
hundreds of management processors, only 25 management processors are upgraded simultaneously.
Network activity is considerable during this process.
If an upgrade fails, a message is displayed in the Results column, and the utility continues to upgrade
the other selected management processors.
5. After the upgrade is complete, click Next.
Selecting directory configuration options
After you click Next in the Upgrade Firmware on Management Processors window, the next task is to
select the management processors to configure, and to specify the directory options to enable.
Procedure
1. Navigate to the Select the Desired Configuration window if it is not already open.
338 Selecting directory configuration options
To Next Page
Loading...
Need help?
General