• There is no limit on the number of iLO systems that can be in a group.
• You must have the Configure iLO Settings privilege to configure group memberships.
• You can use the iLO web interface to configure group memberships for a local iLO system or a group
of iLO systems.
• You can use RIBCL XML scripts to view and configure group memberships.
For more information, see the iLO Federation user guide.
• You can use the iLO RESTful API to configure group memberships.
For more information, see the iLO RESTful API documentation at the following website: http://
www.hpe.com/support/restfulinterface/docs.
• Hewlett Packard Enterprise recommends installing the same version of the iLO firmware on iLO
systems that are in the same iLO Federation group.
Managing iLO Federation group memberships (local iLO system)
Viewing iLO Federation group memberships (local iLO system)
Procedure
Click iLO Federation in the navigation tree.
You can also use RIBCL scripts to view information about groups. For more information, see the iLO
Federation user guide.
The Group Membership for this iLO table lists the name of each group that includes the local iLO
system, and the privileges granted to the group by the local iLO system.
Adding iLO Federation group memberships
Prerequisites
Configure iLO Settings privilege
Procedure
1. Click iLO Federation in the navigation tree.
The Setup tab is displayed.
2. Click Join Group.
3. Enter the following information:
• Group Name—The group name, which can be 1 to 31 characters long.
• Group Key—The group password, which can be from the configured minimum password length to
31 characters long.
• Group Key Confirm—Confirm the group password.
Managing iLO Federation group memberships (local iLO system) 87
To Next Page
Loading...
Need help?
General