The information displayed on this page depends on your storage configuration. Some storage
configurations will not display information for every category.
Fibre Channel adapters are not listed on this page. To view information about Fibre Channel adapters,
click System Information in the navigation tree, and then click the Network tab.
Procedure
1. Click System Information in the navigation tree, and then click the Storage tab.
2. Optional: To expand or collapse the data, click Expand All or Collapse All, respectively.
3. Smart Array controllers only: For the controller you want to view, select one of the following options:
• Logical View—View configured logical drives and associated physical drives. This view does not
show physical drives that are not configured as part of an array, or spare drives.
• Physical View—View physical drives. This view does not show logical drives.
Supported storage components
The Storage Information page displays information about the following storage components:
• Smart Array controllers, drive enclosures, the attached logical drives, and the physical drives that
constitute the logical drives.
• Hewlett Packard Enterprise and third-party storage controllers that manage direct-attached storage,
and the attached physical drives.
iLO 5 supports the following products:
â—¦ HPE ML/DL Server M.2 SSD Enablement Kit
â—¦ HPE 12G SAS Expander
â—¦ HPE Dual 8GB MicroSD EM USB Kit
â—¦ NVMe drives
Smart Array controllers are listed first on the page, followed by other Hewlett Packard Enterprise and
third-party storage controllers.
Smart Array details
iLO displays information about controllers, enclosures, logical drives, and physical drives.
iLO can monitor 256 physical drives total and 256 logical drives total.
Controllers
This section provides the following details for each Smart Array controller.
• Controller location—Slot number or system board
• Top-level controller status (displayed on the left of the controller location)—A combination of the
controller hardware status and the status of cache modules, enclosures, and physical, logical, and
spare drives associated with the controller. If the controller hardware status is OK, and any associated
hardware has a failure, the top-level controller status changes to Major Warning or Degraded,
64 Supported storage components
To Next Page
Loading...
Need help?
General