Test alerts are used to verify the network connectivity of iLO with the Trap Destination(s) addresses.
After the alert is generated, check the alert destination for receipt of the alert.
5. To save the configuration, click Apply.
SNMP traps
SNMP traps lists the SNMP traps that you can generate with iLO 5 and supported ProLiant servers and
Synergy compute modules.
Table 3: SNMP traps
Trap
number
Trap name Description
0 Cold Start Trap SNMP has been initialized, the system
has completed POST, or AMS has
started.
4 Authentication Failure Trap SNMP has detected an authentication
failure.
1006 cpqSeCpuStatusChange An uncorrectable machine check
exception has been detected in a
processor.
1010 cpqSeUSBStorageDeviceReadErrorOccurred A read error occurred on an attached
USB storage device.
1011 cpqSeUSBStorageDeviceWriteErrorOccurred A write error occurred on an attached
USB storage device.
1012 cpqSeUSBStorageDeviceRedundancyLost USB storage device redundancy was
lost.
1013 cpqSeUSBStorageDeviceRedundancyRestored USB storage device redundancy was
restored.
1014 cpqSeUSBStorageDeviceSyncFailed The sync operation to restore USB
storage device redundancy failed.
1015 cpqSePCIeDiskTemperatureFailed The temperature of the PCIe disk
crossed the upper critical threshold.
1016 cpqSePCIeDiskTemperatureOk The temperature of the PCIe disk is
normal.
1017 cpqSePCIeDiskConditionChange The status of the PCIe disk changed.
1018 cpqSePCIeDiskWearStatusChange The PCIe disk wear status changed.
1019 cpqSePciDeviceAddedOrPoweredOn A PCI disk was added or powered on.
Table Continued
284 SNMP traps
To Next Page
Loading...
Need help?
General