3-1
3
Setup Network
You can use the Setup Network pages to configure how a management computer connects to the switch and how
the switch connects to a server to synchronize its time.
Get Connected
Use the Get Connected page to configure settings for the network interface. The network interface is defined
by an IP address, subnet mask, and gateway. Any one of the switch's front-panel ports can be selected as the
management port for the network interface. The configuration parameters associated with the switch's network
interface do not affect the configuration of the front-panel ports through which traffic is switched or forwarded
except that, for the management port, the port VLAN ID (PVID) will be the management VLAN.
To display the Get Connected page, click Setup Network > Get Connected.
In the example configuration in Figure 3-1, the switch is configured to acquire its IP address through DHCP,
which is the default setting. Access to the management software is restricted to members of VLAN 1.
Figure 3-1. Get Connected Page
To Next Page
Loading...
Need help?
General
