2-6 Removal and Replacement HP Omnibook 500
Removing the Hard Disk Drive
(User-Replaceable)
Table 2-4. Hard Disk Drive Replacement Part Numbers
Description Part Number Exchange Part Number
Drive, hard disk (7.5 GB, 9.5 mm, Hitachi) 0950-4011 F2112-69002
Drive, hard disk (7.5 GB, 9.5 mm, IBM) 0950-4030 F2112-69003
Drive, hard disk (10 GB, 9.5 mm, IBM, DJSA-210) 0950-3934 F1660-69112
Drive, hard disk (10 GB, 9.5 mm, Toshiba,
MK1016 GAP)
0950-3985 F2072-69109
Drive, hard disk (20 GB, 9.5 mm, IBM, DJSA-220) 0950-3935 F1660-69113
Drive, hard disk (30 GB, 9.5 mm, IBM part no.
07N6714)
0950-4162 F2072-69115
Required Equipment
•
#0 Phillips screwdriver.
Removal Procedure
1.
Unplug the AC adapter, if present, and remove the battery.
2.
From the bottom of the unit, remove the hard drive retaining screw.
3.
Carefully pull the hard drive out of the computer.
Figure 2-4. Removing the Hard Disk Drive
4.
Remove all four screws from the tray and drive case, then lift the drive out of the tray.
5.
Notice that the hard drive has a pin connector attachment at one end. Carefully remove this
connector from the end of the drive. Work alternately at each side so that the connector slides off
evenly without bending the connector pins.
Screw, M2×3mm
To Next Page
Loading...
Need help?
General