Memory module
Description Spare part number
4 GB 599092–001
2 GB 598956–001
1 GB 598859–001
Before removing the memory module:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first disconnecting the power cord from the AC outlet
and then disconnecting the AC adapter from the computer.
4. Remove the
Battery on page 43.
5. Remove the
Hard drive cover on page 44.
To remove the memory module:
1. Position the computer with the front toward you.
2. Spread the retaining tabs (1) on each side of the memory module slot to release the memory
module. The edge of the module opposite the slot rises away from the computer.
NOTE: If necessary, use a non-conductive pointed tool to spread the retaining tabs.
3. Remove the module (2) by pulling it away from the slot at an angle.
NOTE: Memory modules are designed with a notch to prevent incorrect insertion into the
memory module slot.
ENWW
Component replacement procedures
49
To Next Page
Loading...
Need help?
General