Removal and Replacement Procedures
HP ProLiant ML150 Generation 2 Server Maintenance and Service Guide 2-17
HP CONFIDENTIAL Codename: Stone Soup 2 Part Number: 368148-003 Last Saved On: 6/10/05 4:28 PM
Boot Priority
The server’s boot order should be considered when selecting a boot device. This is especially
important if you are installing a board that requires a higher priority in the boot order. The
board’s boot priority is set by its slot location in the boot order.
By default, the server searches for boot devices in the following order:
1. Legacy Floppy Drives (for the flexible diskette drive or virtual floppy)
2. USB FDD: (for the external USB floppy diskette drive)
3. IDE 0: (for the IDE CD-ROM drive)
4. USB HDD: (for the external USB hard disk drive or flash disk)
5. USB CDROM: (for the external USB CD-ROM drive)
6. SCSI/SATA: (for the SCSI or SATA hard disk drive)
7. PXE: (for the embedded LAN)
8. (reserved for additional boot devices)
NOTE: The boot order can be changed using the server’s BIOS Setup Utility.
To Next Page
Loading...
Need help?
General