To Next Page

To Previous Page

Fabric OS Administrator’s Guide 93

53-1002446-01

The boot PROM password

The boot PROM password provides an additional layer of security by protecting the boot PROM from

unauthorized use. Setting a recovery string for the boot PROM password enables you to recover a

lost boot PROM password by contacting your switch service provider. Without the recovery string, a

lost boot PROM password cannot be recovered.

Although you can set the boot PROM password without also setting the recovery string, it is strongly

recommended that you set both the password and the recovery string. If your site procedures

dictate that you set the boot PROM password without the recovery string, see “Setting the boot

PROM password for a switch without a recovery string” on page 95.

To set the boot PROM password with or without a recovery string, refer to the section that applies to

your switch or Backbone model.

CAUTION

Setting the boot PROM password requires accessing the boot prompt, which stops traffic flow

through the switch until the switch is rebooted. Perform this procedure during a planned

downtime.

Setting the boot PROM password for a switch with a recovery string

This procedure applies to the following switch models: Brocade 300, 5410, 5424, 5450, 5460,

5470, 5480, 5100, 5300, 65,10, 7800, 8000, and 8510 switches. If your switch is not listed,

please contact your switch support provider for instructions.

1. Connect to the serial port interface as described in “Connecting to Fabric OS through the serial

port” on page 16.

2. Reboot the switch.

3. Press ESC within four seconds after the message “Press escape within 4 seconds...” displays.

The following options are available:

4. Enter 2.

• If no password was previously set, the following message displays:

Recovery password is NOT set. Please set it now.

• If a password was previously set, the following messages display:

Send the following string to Customer Support for password recovery:

afHTpyLsDo1Pz0Pk5GzhIw==

Enter the supplied recovery password.

Recovery Password:

Option Description

1 Start system. Continues the system boot process.

2 Recovery password. Lets you set the recovery string and the boot PROM password.

3 Enter command shell. Provides access to boot parameters.

HP SN3000B User Manual

Other manuals for HP SN3000B