Installing the autoloader14
Unpacking the autoloader:
1. Before opening and removing the autoloader from the shipping container, inspect the container
for shipping damage. If you notice any damage, report it to the shipping company immediately.
2. Open the shipping container; remove and set aside the accessory package.
CAUTION: Do not set the autoloader on either end or sides.
3. Lift the autoloader and padding out of the container and place it on the work surface, top facing
up.
4. Carefully remove the shipping materials from the left and right sides of the autoloader. Remove
the bag from the autoloader. Save the packing materials in case you need to move or ship the
autoloader in the future (see Figure 3).
Figure 3 Removing the autoloader from the shipping container
Identifying product components
Confirm that you have received the following:
• SCSI cable
• SCSI terminator
• Power cable
• Documentation kit
• Documentation CD
• Installation Poster
• HP OpenView Storage Data Protector Installation Instructions
•HP Worldwide Warranty
•HP Safety Guide
To Next Page
Loading...
Need help?
General