EasyManuals Logo

HP StorageWorks Ultrium 230 User Manual

HP StorageWorks Ultrium 230
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
Ultrium 960, Ultrium 448, Ultrium 460, Ultrium 230, DLT VS80, SDLT 320 31
3. Press + or - until the desired slot number displays on the LCD screen and press Enter. You are not
given the option to export from an empty slot, and you cannot export directly from the drive.
When Remove Cartridge displays on the LCD screen and the cartridge is ejected through the
mailslot, remove the exported cartridge from the autoloader and press Enter. (See Figure 14.)
4. Repeat steps 3 and 4 as needed for any additional cartridges.
5. Press Cancel when you have finished exporting cartridges.
6. Check the LCD screen to verify that the desired slots no longer contain cartridges.
Figure 14 Exporting a cartridge
Bulk Exchange (Ultrium 960 and Ultrium 448 only)
This option allows you to import or export a specific number of cartridges and is useful if you want
to exchange a complete set of cartridges. Bulk Exchange operation starts with slot #1. If a cartridge
is available this cartridge will be exported. You must then import a new cartridge or move to the
next slot #2. The procedure is repeated for slot #2 to slot #8.
NOTE: You must go offline to run Bulk Exchange and Import from the Commands menu. See ā€To
access Offline modeā€ on page 26.
Loading tape cartridges
This option loads a cartridge from the autoloader slots into the tape drive. To use this option:
1. Ultrium 960 and Ultrium 448: From the Home Screen, press + or - until Go Offline displays
on the top line of the LCD screen. Press Enter to select. Press + or - until Commands displays on
the top line of the LCD screen. Press Enter to select.
All other models: From the Home Screen or Main menu, press + or - until Commands displays on
the top line of the LCD screen. Press Enter to select.
2. Press + or - until Load Cartridge displays on the LCD screen. Press Enter to select.
3. Press + or - until the desired slot number displays on the LCD screen and press Enter. The slot
number you select indicates the cartridge to be loaded into the tape drive.
NOTE: Only slot numbers containing cartridges are displayed.

Table of Contents

Other manuals for HP StorageWorks Ultrium 230

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP StorageWorks Ultrium 230 and is the answer not in the manual?

HP StorageWorks Ultrium 230 Specifications

General IconGeneral
BrandHP
ModelStorageWorks Ultrium 230
CategoryStorage
LanguageEnglish

Related product manuals