Ultrium 960, Ultrium 448, Ultrium 460, Ultrium 230, DLT VS80, SDLT 320 57
2. Press + or - until Error Log (Ultrium 960 and Ultrium 448) or View Event Log (all other
models) displays on the LCD screen. Press Enter to access the most recently logged error
message.
3. Press + or - to display each error in the log.
4. Press Cancel when done.
Example error code (Ultrium 960 and Ultrium 448)
EVENT -6
A5 F1
where:
• Sequence number –6 indicates the position in sequence list, 0 being the most recent.
• Log shows a load error (code A5 = fan error, subcode F1 = caused by the fan at the rear
connector plate).
The event log with the Ultrium 960 and Ultrium 448 Tape Autoloaders also includes a datestamp for
each event. Press Enter to display the associated timestamp in the following format:
ddd:hh:mm:ss:HH
where:
ddd: days
hh: hours
mm: minutes
ss: seconds
HH: 1/100 second
The timestamp is set to zero at system start.
NOTE: On all other models, error codes are listed in the format 3 0 xx, where xx is the error
code, and there is no subcode. The 3 indicates the entry is an error and the 0 is an unused byte. A
fan error would be 3 0 A5, and there would be no indication which fan had failed.
To Next Page
Loading...
Need help?
General