EchoLife HG850
Service Manual 3 Service Configuration
Issue 02 (2007-05-30) Huawei Technologies Proprietary 3-7
3.3.3 Configuring MGCP Data
Configuring IP Address of the HG850
In the general configuration mode, configure the IP address of the HG850. The
configuration commands are as follows.
Operation Command
Configure the HG850 to obtain a fixed IP address:
ipaddress static
ip-address net-mask gateway-ip
Configure the HG850 to automatically obtain an IP
address:
ipaddress dhcp
Configure the IP address
of the HG850
Configuring the HG850 to obtain an IP address by the
PPPoE dialing:
z
pppoe username username password password
z
ipaddress pppoe { disable | enable }
The IP address of the HG850 must be configured. After being configured, the IP address
can take effect at once without rebooting.
The IP address of the HG850 can be obtained in three ways:
z
Configuring a fixed IP address
z
Dynamically obtained from the DHCP server
z
Obtained through the PPPoE dialing mode
z
The HG850 can only configure one mode for the IP address.
z
When you are dynamically obtaining the IP address, such as through the DHCP and
PPPoE modes, you need not configure the DNS server information.
Configuring Domain Name of MG for Registration
In the general configuration mode, configure the domain name of the HG850. The
configuration command is as follows.
Command Remarks
TERMINAL(config)#
mgcp
mg-domain-name
name
Name: The domain name of the HG850, containing
1–60 characters.
The domain name should be consistent with that
configured on the MGC server.
Example:
Configure the domain name of the HG850 as huawei.com.
To Next Page
Loading...
Need help?
General
