Husqvarna TX 125 User Manual

12 SERVICE WORK ON THE CHASSIS
55
V01005-10
–
Loosen screws
3
. Take out the left fork leg.
–
Loosen screws
4
. Take out the right fork leg.
12.6 Installing the fork legs
402556-10
Main work
– Position the fork legs.
Bleeder screws
1
are positioned toward the front.
Info
The rebound damping is located in the right fork leg
(red adjusting screw). The compression damping is
located in the left fork leg (white adjusting screw).
Grooves are milled into the side of the upper end of
the fork legs. The second milled groove (from the top)
must be flush with the top edge of the upper triple
clamp.
V01005-11
–
Tighten screws
2
.
Guideline
Screw, top triple
clamp
M8 17 Nm (12.5 lbf ft)
–
Tighten screws
3
.
Guideline
Screw, bottom triple
clamp
M8 15 Nm (11.1 lbf ft)
V00930-10
–
Position the brake caliper, and mount and tighten screws
4
.
Guideline
Screw, front
brake caliper
M8 25 Nm (18.4 lbf ft)
Loctite
®
243™
– Mount the cable tie(s).
– Position the brake line, wiring harness, and clamp. Mount and
tighten screws
5
.
Finishing work
– Install the front wheel. ( p. 98)
– Install the headlight mask with the headlight. ( p. 108)
– Check the headlight setting. ( p. 109)

Husqvarna TX 125 Specifications

General

Brand	Husqvarna
Model	TX 125
Category	Motorcycle
Language	English