Husqvarna TX 125 User Manual

12 SERVICE WORK ON THE CHASSIS
58
402556-12
– Position the fork legs.
Bleeder screws
7
are positioned toward the front.
Info
The rebound damping is located in the right fork leg
(red adjusting screw). The compression damping is
located in the left fork leg (white adjusting screw).
Grooves are milled into the side of the upper end of
the fork legs. The second milled groove (from the top)
must be flush with the top edge of the upper triple
clamp.
V01006-10
–
Tighten screws
8
.
Guideline
Screw, bottom triple
clamp
M8 15 Nm (11.1 lbf ft)
V00990-10
–
Tighten screw
4
.
Guideline
Screw, top steering
head
M20x1.5 12 Nm (8.9 lbf ft)
V00991-10
–
Mount and tighten screw
9
.
Guideline
Screw, top
steering stem
M8 17 Nm (12.5 lbf ft)
Loctite
®
243™
V01006-11
–
Tighten screws
bk
.
Guideline
Screw, top triple
clamp
M8 17 Nm (12.5 lbf ft)

Husqvarna TX 125 Specifications

General

Displacement	124.8 cc
Bore x Stroke	54 mm x 54.5 mm
Starter	Kickstarter
Transmission	6-speed
Seat Height	960 mm
Ground Clearance	370 mm
Engine Type	Single cylinder, 2-stroke
Rear Suspension	WP XACT shock absorber with linkage
Front Brake	260 mm disc
Rear Brake	220 mm disc
Clutch	Wet, multi-disc clutch, hydraulically operated