Hypertherm ArcGlide THC User Manual

ArcGlide THC Instruction Manual 806450 139
3–Operation
Screen 5 – Inputs from the lifter control board
Lower Limit: The lower limit of motion on the lifter has been reached. On/Off
Upper Limit: The upper limit of motion on the lifter has been reached. On/Off
Breakaway: The breakaway sensor has detected a torch collision. On/Off
Lifter Up: Indicates that the lifter is moving up. On/Off
Lifter Dwn: Indicates that the lifter is moving down. On/Off
Lifter Enable: Indicates that the lifter is enabled at the lifter. On/Off
Screen 6 – Outputs from the lifter control board
Encoder Error: Indicates that there is an error from the lifter motor. See Screen 11 – Last errors on page 142 for more
information. Yes/No
Encoder Dir: Displays the direction in which the lifter is moving. Up/Dwn.
Enc Count: Displays the distance from home that the lifter has traveled, in encoder counts.
Tip Sense: Indicates that the torch has touched the workpiece. This is active only for tip touch plate detection and the
value corresponds with the illumination of the TIP-TOUCH LED on the front of the control module. On/Off
Brake: Indicates that the lifter brake is activated. On/Off
Motor: Indicates that the lifter motor is operating. On/Off
5LIFTER INPUTS
Lower Limit Off Lifter Up Off
Upper Limit Off Lifter Dwn Off
Breakaway Off Lifter Enable On
6LIFTER OUTPUTS
Encoder Error No Tip Sense Off
Encoder Dir Dwn Brake Off
Enc Count 456262 Motor On

Hypertherm ArcGlide THC Specifications

General

Brand	Hypertherm
Model	ArcGlide THC
Category	Control Systems
Language	English