Hypertherm ArcGlide THC User Manual

92 ArcGlide THC Instruction Manual 806450
2 – Installation
Connect Hypernet cables
A system configuration in which there is more than one Hypernet connection requires an industrial-grade Ethernet switch.
See Ethernet switch on page 46 for more information.
In this type of configuration, Hypernet connections are made from the ArcGlide control module directly to the Ethernet
switch and from there to the CNC or plasma system. See Figure 11 on page 59 for an example.

Each unit assigned to a station must have the same Hypernet address. This common address between units allows
the Ethernet switch to direct communications to the appropriate station. See Figure 25 for an example.
Figure 25
See the following pages for details:
 See Assign an ArcGlide THC to a station on page 125 for information about linking unit addresses to a station in
Phoenix software on a Hypertherm CNC.
 See the following sections for the location of the unit address switches:
 HMI processor board (228581) on page 211
 THC processor board (228578) on page 220
 Hypernet plasma interface board (141162) on page 228

Hypernet connections and Ethernet connection to a LAN cannot be made through the same switch. If your cutting
machine is connected to a LAN over Ethernet, you must use a separate Ethernet switch for these connections.
Station 1
Lifter
HPR plasma system
HMI
Hypernet address: 1
ArcGlide control module
Hypernet address: 1
Hypernet plasma interface
board
Hypernet address: 1
HyPath CNC Ethernet switch
Station 2
HMI
Hypernet address: 2
ArcGlide control module
Hypernet address: 2
HPR plasma system
Hypernet plasma interface
board
Hypernet address: 2
Lifter
Key:
Hypernet connection
Discrete connection

Hypertherm ArcGlide THC Specifications

General

Brand	Hypertherm
Model	ArcGlide THC
Category	Control Systems
Language	English