Hypertherm ArcGlide THC User Manual

ArcGlide THC Instruction Manual 806450 165
3–Operation
Internal feature (hole)
 Torch travels counterclockwise.
 Good side of the cut is to the right side of the torch as it travels forward.
Step 2: Was the correct process selected for the material and thickness being cut?
Refer to the cut charts in the Operation section of the Hypertherm Instruction Manual. On the CNC, choose the Cut
Chart soft key on the Main Screen to view the cut chart for the selected torch type, material and thickness.
Follow the specifications in the cut charts:
 Select the appropriate process for:
 Material type
 Material thickness
 Desired cut quality
 Productivity goals
 Select the correct plasma and shield gas.
 Select correct parameters for:
 Gas pressures (or flow rates)
 Cut height and arc voltage
 Cutting speed
 Confirm that the correct consumables are being used and verify the part numbers.

Generally, lower amperage processes offer better angularity and surface finish. However, cutting speeds are slower
and dross levels are higher.
End point
Start point

Hypertherm ArcGlide THC Specifications

General

Brand	Hypertherm
Model	ArcGlide THC
Category	Control Systems
Language	English