Hypertherm HySpeed HT2000LHF User Manual

INSTALLATION
3-6 HySpeed HT2000LHF Instruction Manual
7
1. Insert the power cable through the strain relief at the lower left rear of the power supply. Connect the power
cable leads to TB1 located at the center wall, right side.
2. Connect the power leads to the L1, L2, and L3 terminals of TB1. See Fig. 3-1.
3. Connect the ground lead as shown.
Figure 3-1 Power Cable Connections
Ground lead
To connect the power
cable to the 400V CE
power supplies refer to
the appendix section.
WARNING
There is line voltage at the contactor if the line disconnect switch is in the ON position, even if the
ON (1) pushbutton on the power supply has not been pressed. As a common safety practice,
AL
WAYS verify that the line disconnect switch is in the OFF position before installing, disconnecting
or servicing in this area.
Connecting the Power (continued)

Hypertherm HySpeed HT2000LHF Specifications

General

Brand	Hypertherm
Model	HySpeed HT2000LHF
Category	Welding System
Language	English