IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer User Manual

Status sent to system
RS-232 Syntax:
ESC ) n or X'1B29;n'
where:
n Select function.
Bit # ↓ Function Bit=0 Bit=1
LSB 0 Print Buffer Empty/Full Yes No
1 Reserved Yes No
2 Front Document Sensor Change Yes No
3 Top Document Sensor Change Yes No
4 After status byte 6 is incremented or
status byte 3, bit 7, is set
Yes No
5 Cash Draw Sensor Change Yes No
6 Key In Use Yes No
7 Cover Open Yes No
Remarks:
Bit 4 can be used in place of the Command Complete. When the buffer is
empty, the system can assume that everything stored in the printer has
been completed. To enable these status messages, unsolicited status must
be enabled. See “Asynchronous (real-time) commands” on page 161.
Select character for reprinted lines
RS-232 Syntax:
ESC + n or X'1B2B;n'
where:
n The ASCII representation of the character printed in the first
character position on the print line when recovering from a home
error. This occurs in impact print stations only.
Default:
n = 2A hex (This is an asterisk (*) in most code pages.)
Remarks:
The value is stored in EEPROM to prevent loss when the printer is reset.
The default value after the reset is the value last sent.
Reinitialize the printer
RS-232 Syntax:
ESC @ or X'1B40'
Purpose:
Reinitialize all printer setting to their default values and reset the impact
printhead.
Remarks:
Commands in the print buffer are not lost when this command is issued.
The settings that are reinitialized follow (all numbers are in hex):
August 24, 2004
Appendix C. RS-232 programming information 139

IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer Specifications

General

Brand	IBM
Model	4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer
Category	Printer
Language	English