IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer User Manual

If this message is printed on a regular basis, consider downloading it to
save communication time. (See “Download graphics (logo) Commands” on
page 112.)
The data buffer in the Model TI3 and Model TI4, which is 16 KB, can be
used for signature capture.
Print predefined graphics (logo) command
RS-232 Syntax:
GS / m logo# or X'1D2F;m;logo#'
where:
m The dot-density:
00 Normal Print - 200 dpi in the receipt station, 150 dpi in the
document station.
Note:
In the document station, this takes three passes of
the printhead for a logo that is 8 dots high.
01
Double wide - 100 dpi in the receipt station, 75 dpi in the
document station.
Note:
In the document station, this takes one pass of the
printhead for a logo that is 8 dots high.
02 Double wide and high - 100 dpi in the receipt station, 75 dpi
in the document station. Every dot row in the vertical
direction will be printed twice.
logo
# The number associated with the logo that is stored.
v range = 1 to 40 for all models except TI8
v range = 1 to 255 for Model TI8
Purpose:
To print predefined all-points-addressable print messages.
Remarks:
The margin is ignored if it causes the logo to overrun the line length.
Printing this message in the document station at 150 dpi will take three
passes of the printhead.
These messages can be positioned on the page using the commands for
setting positions.
Valid at the beginning of the line only.
This command is not valid in landscape mode.
This command will increment status byte 6.
Retries will not be attempted on print errors.
In the document portrait station, a line feed command must be sent to
advance the paper past the last line of the logo.
See “Download graphics (logo) Commands” on page 112.
August 24, 2004
154 SureMark Printers User’s Guide
|
|

IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer Specifications

General

Brand	IBM
Model	4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer
Category	Printer
Language	English